Taylor-Dunn MX-026-00, Руководство по эксплуатации, обслуживанию и замене запасных частей, Страница: 75 / 192

Maintenance, Service, and Repair
Transaxle - SS-534
Page 3
TRANSAXLE ASSEMBLY
Remove
6. Disconnect the motor terminals.
7. Raise the rear of the vehicle just enough to lift the
weight off of the rear wheels, the wheels should still
be touching the ground.
8. Remove the lower shock bolt.
9. Disconnect the brake cable.
10. Remove the two swing arm pivot bolts.
11. Raise the frame and remove the transaxle assembly
from under the vehicle.
18. Lower the frame to the ground or leave supported
on jack stands.
Install
1. Install in reverse order of removal.
•
Use a new cotter pin for the brake cable.
•
Adjust the brake linkage and brake band.
•
Tighten the motor terminals per torque listed in
the Hardware Torque table at the end of this
section.
Always use a lifting strap, hoist, and jack
stands, of adequate capacity to lift and support
the vehicle. Failure to use lifting and support
devices of rated load capacity may result in
severe bodily injury.
1. Make sure the start switch is in the “OFF”
position, then remove the key.
2. Place the forward-reverse switch in the
center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the battery main positive and
negative terminals.