Taylor-Dunn MX-026-00, Руководство по эксплуатации, обслуживанию и замене запасных частей

Страница: 67 / 192

Maintenance, Service, and Repair
Transaxle - SS-536, SS-546, MX-600
Page 5
MOTOR
Remove
NOTE: In some vehicle configurations the transmission
assembly will have to be removed to allow clearance
to remove the motor. Refer to Transmission section
for information on removing the transmission
assembly from the vehicle.
6. Remove the motor wires from the motor.
7. Remove the bolts holding the motor to the
transmission housing (see illustration).
8. Slide the motor off of the transmission input shaft.
Install
1. Remove the rubber bushing from inside of the motor
armature coupler (see illustration).
2. Thoroughly clean all grease from the transmission
input shaft, rubber bushing and the motor armature
coupling.
3. Install the rubber bushing back into the motor
armature coupling.
4. Lightly grease the transmission input shaft only (see
caution).
5. Install the motor in reverse order.
•
Tighten the motor mounting bolts per torque
listed in the Hardware Torque table at the end
of this section.
•
Tighten the motor terminals per torque listed in
the Hardware Torque table at the end of this
section.
1. Make sure the start switch is in the “OFF”
position, then remove the key.
2. Place the forward-reverse switch in the
center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the battery main positive and
negative cables.
Always use a lifting strap, hoist, and jack
stands, of adequate capacity to lift and support
the vehicle. Failure to use lifting and support
devices of rated load capacity may result in
severe bodily injury.
Do not apply grease to the armature coupler,
rubber bushing or the end of the transmission
input shaft. Grease applied to these areas may
result in premature failure of the armature
bearing.