TAVRIDA ELECTRIC ISM Shell_2 Series, Руководство по применению

Страница: 34 / 83

34
33
Figure 50
Stationary type installation
3
1
2
5
4
Figure 51
Draw out type installation
6
2
7
3
4
5
1
Steel plate
> 1 mm thick
ISM
CM
Closed steel box
> 1 mm thick
Shielded cable
Secondary
circuit plug
Secondary
components
1
2
3
4
5
6
7
Ins tallation of the CM
The installation of the CM is carried out according to the panel design either on the draw out unit or in the low
voltage compartment of the switchboard. It must be separated from the high voltage compartment. The CM shall
be installed in an grounded mild steel box with a thickness of not less than 1 mm.
The CM can operate in any mounting position. Care must be taken for good access and visibility of the terminals,
LEDs and setting elements for operation and maintenance. Basically the ambient conditions as described in chapter
“Regulations and ambient conditions” (page 73) shall apply.