TATA Motors ALTROZ BS VI 2021, Руководство пользователя

Страница: 170 / 248

162
Screw the bottle clockwise firmly 4.
against the slight resistance of the
notches onto the sealing gasket of the
bottle connector until it is screwed
tight.
Remove the valve cap from the dam-
5.
aged tire. Pull the protective cap off the
end of the hose and screw the hose
firmly onto the valve of the damaged
tire. Make sure that the compressor
switch is switched to “0” and the pres-
sure “air release” valve is closed.
Insert power plug into the 12 volt
6.
power socket connection.
Start the engine (only if the vehicle is
7.
outdoors or in a well ventilated area).
Press compressor switch to “I”. 8. Inflate the tire within about 10 minutes 9.
to an inflation pressure of minimum
180 kPa, (1.8 bar, and 26 psi) and a
maximum of 300 kPa (3 bar, 43 psi).
Switch off the compressor briefly in
10.
order to read the actual tire pressure
from the pressure gauge.
WARNING
Leave the bottle seal intact. Screwing
the bottle onto the bottle holder will
pierce the seal of the bottle. Avoid skin
contact with the sealant which contains
natural rubber latex. Do not open pres-
sure “air release” valve. Please use pro-
tective glove for safety purpose.
WARNING
Asphyxiation may occur if the engine is
allowed to run in a non-ventilated or
poorly ventilated area (e.g. inside a
building)
NOTE
Check the sidewall of the tire prior to in-
flation. If there are any cracks, bumps
or similar damage, do not attempt to in-
flate the tire. Do not stand directly be-
side the tire while the compressor is
pumping. Watch the sidewall of the tire.
If any cracks, bumps or similar damage
appear, turn off the compressor and let
the air out by means of the pressure “air
release” valve. In this case, do not con-
tinue to use the tire.
NOTE
When pumping in the sealant through
the tire valve, the pressure may rise up
to 500 kPa (5 bar, 73 psi) but will drop
again after about 30 seconds.
WARNING
If heavy vibrations, unsteady steering
behavior or noises should occur while
driving, reduce your speed and drive
with caution to a place where it is safe
for you to stop the vehicle. Recheck the
tire and its pressure. If the tire pressure
is less than 130 kPa (1.3 bar, 19 psi) or
if there are any visible cracks, bumps or
similar damage on the side wall, do not
continue to use the tire!
EMERGENCY AND BREAKDOWN ASSISTANCE