24
22.7. Inspect Squeegee
Check the squeegee blades for wear.
Flip worn blades and replace if necessary.
22.8. Inspect and Replace Scrubber Pads
Unlatch and open the front cover. Inspect the scrubber pads.
Replace if pads are worn to within 10 mm of brushes.
To replace the pads, rotate the brushes toward the center of
the machine to release the brush.
Figure: 48
Replace the pad on the brush. Replace the brush on the
head by rotating in the opposite direction.
Inspect pads for wear and replace if
necessary.
Flip the pads every other day to extend
brush life.
Close the front door and secure both latches.
22.9. Fill the Tank
Fill the tank with 14 gallons (53 liters) of cool water.
Diversey recommends using cold water
since hot water will adjust to the floor
temperature as soon as it is in contact with
the floor. Thus there are no advantages to
the using of hot water.
Add recommended cleaning solution
to the water in the tank according to
the manufacturer’s instructions. Use of
protective glasses, gloves, and apron is
recommended.
Only use cleaning products recommended
by TASKI Intellibot. Use of products
containing chlorine, acids, or unsuitable
solvents may damage the machine and
may be hazardous to the operator.
22.10. System Power Up
Perform the following steps to power up the system.
Turn on the system by pressing the standby
button.
Wait approximately 2 minutes until the LOG IN screen is
displayed.
Figure: 49
Confirm "CE" is in lower left of screen as a
software update may have occurred since
last use.
••••••
1 2 3
4 5 6
7 8
0
9
x
Press the LOG IN key and enter your
operator password.
You will be prompted with a series of
screens to guide you through machine
preparation steps. Touch any of these
screens for more information.
Release the parking brake by moving the red lever to the
right.
Figure: 50
Press the OK button to begin using the
machine.
23. Review of Work Area
Before beginning cleaning, the operator is responsible for
reviewing and preparing the work area.
Remove any objects from the floor that
could get caught or be thrown by the
scrubber head. Objects entangled or
thrown by the scrubber could cause serious
property or machine damage and injury.
