Tascam SS-CDR250N, Руководство пользователя

Страница: 60 / 112

60
TASCAM SS-CDR250N / SS-R250N
8 – Recording
Using the dynamics function
By turning the dynamics function on, you can apply this unit's
limiter or compressor to recording sources and prevent input
signal levels from overloading during recording.
1.
Select
DYNAMICS
on the
REC 2
page to open the
DYNAMICS
screen. (See “Menu operation procedures” on page 22.)
2.
Set the input signal dynamics function.
Option Meaning
OFF
(default) Do not use the dynamics function.
LIMITER
This applies the limiter.
This suppresses distortion of sound due to
sudden excessive input.
COMP_SOFT
This applies light compression.
This setting is good for music.
COMP_HARD
This applies heavy compression.
This setting is good for recording meetings
and similar situations.
NOTE
i
When the dynamics function is on, the , or
icon appears in the recording function activation sta-
tus area on the recording screen.
i
Distortion of sounds may occur when signals that are very
loud are input even when the limiter is activated. In such a
case, lower the recording level or increase the distance be-
tween the mic and the sound source.
i
Compressors are effects that suppress peak sounds and make
audio easier to hear overall by raising and lowering levels for
a more even volume.
i
When
REC SET LINK
is set to
OFF
on the
REC 1
page, the
levels of the left and right channel inputs are adjusted sepa-
rately. In this case, the left channel setting will be shown on
the Home Screen when recording or in recording standby. If
the left channel setting is
OFF
, but the right channel setting
is not OFF , however, the right channel setting will be shown
on the Home Screen. (See “Setting left/right channel inputs
separately” on page 57.)
3.
Confirm the setting and return to the Menu Screen.
Setting the low-cut filter
The low-cut filter can reduce bothersome noise, such as from
wind, air-conditioners and projectors.
1.
Select
LOW CUT
on the
REC 2
page to open the
LOW CUT
screen. (See “Menu operation procedures” on page 22.)
2.
Set the cutoff frequency of the low-cut filter used during
input.
Options:
OFF
(default),
40Hz
,
80Hz
,
120Hz
,
180Hz
,
220Hz
NOTE
i
When the low-cut filter function is on, the icon appears in
the recording function activation status area on the recording
screen.
i
When
REC SET LINK
is set to
OFF
on the
REC 1
page, the lev-
els of the left and right channel inputs are adjusted separate-
ly.
3.
Confirm the setting and return to the Menu Screen.