13
ASSEMBLY
7. Before setting on level ground, remove the pin
from the kick stand, flip the kick stand over and set at
desired height.
8. Adjust Skid Shoes as needed.
9. Set the Rotary Tiller on level ground.
10. Install the A-Arms onto
the Rotary Tiller, using the
CAT I pins and the
5/8” x 2” bolts on the
inside of the deck bracing.
*CAT I pins are installed in the front hole and the
(2) 5/8” x 2” grade 5 bolts are installed in the rear.
11. Attach the rounded end of the back brace to the
outside of the rear tiller deck bracing using (2) 5/8” x
2” Grade 5 hex bolt.
12. Repeat for opposite side.
13. Attach the square end of the back brace to the
inside A-Arm plates using 1-1/2” spacer and 5/8” x 4”
hex bolt.
