10
TARGET ECO I FEEDING, rev.09
TARGET ECO I FEEDING
2.4
Step by Step Guide
Use the following check list to make sure
your feeding system is ready. References
to related sections of the manual are pro-
vided to step directly to the parameters'
adjustment chapters.
2.4.1
Connections
•
Connect the main controller and its exter-
nal modules then set an identification num-
ber for each module in use. Refer to the
wiring diagram enclosed with this manual
to make the connections and to set the ID
numbers.
CDM-1 closed-loop control module: ID #1
Proximity sensor module : ID #20
Relay panels: ID #2 to 19
Bridge-A communication module: ID=none
•
Connect the following items to the
CDM-1 module then connect the CDM-1
to the controller. Refer to the controller’s
wiring diagram.
Feeder motor
Proximity sensors
Safety limit switch
Toggle switch (This switch allows stopping
the feeder motor manually without sound-
ing alarms).
•
Wire the desired outputs to the relay
panel(s). Refer to the relay panel’s wiring
diagram to connect the loads :
Fill augers for rations 1-8
Clock outputs (1-8)
Drops (1-96) (if drops are controlled indi-
vidually)
Actuator’s opening and closing relays (if
drops are controlled by an actuator)
Cleanout Auger (optional).
Cleanout valves for rations 1-8 (if a
cleanout auger is used).
Cleanout Master Valve (if a cleanout au-
ger is used).
Air compressor (if a cleanout auger is used
or if drops are controlled individually).
•
Apply power to the system when all out-
puts are properly connected.
Worksheets are provided at the
end of this manual to write
down the relay assignment of
your particular application.
35
TARGET ECO I FEEDING, rev.09
TARGET ECO I FEEDING
11.
WORK SHEETS
CLIENT
Name:
________________________________________________
Address:
________________________________________________
________________________________________________
________________________________________________
City:
________________________________________________
Tel.:
________________________________________________
Fax:
________________________________________________
E-mail:
________________________________________________
INSTALLER
Name:
________________________________________________
Address:
________________________________________________
________________________________________________
________________________________________________
City:
________________________________________________
Tel.:
________________________________________________
Fax:
________________________________________________
E-mail:
________________________________________________