Target ECO I FEEDING, Руководство пользователя, Страница: 20 / 43

20
TARGET ECO I FEEDING, rev.09
TARGET ECO I FEEDING
5.4 Relay Assignment
You must assign On/Off relays to each
output of the controller. In order to make
this assignment, you will need to set the 2
following parameters for each output:
1) Module ID:
The module ID number tells the controller
on which module each relay and proximity
sensor is located. Refer to the wiring dia-
gram enclosed with this manual to set the
ID number of each module.
!
32-Relay panels
Relay panels with 32 relays
must be identified by 2 identifi-
cation numbers : one ID number
to identify the first 16-relay
strip (relays 1-16) and a second
ID number to identify the sec-
ond strip (relays 17-32).
2) Output # :
The output number is the relay on which
the load is connected. Relays are numbered
from 1-16. If the relay panel uses two
16-relay strips (total of 32 relays), relays
#17-32 correspond to relay #1-16 of the
second strip (see table on the right).
Relay panel
with 32 relays
ID # of the
first relay strip
Relays 1-16
of the first
relay strip
Relays 1-16
of the second
relay strip
(relays 17-32)
ID # of the
second relay
strip
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
>> >> >> >> >> >> >> >> >> >> >> >> >> >> >> >>
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Relays 1-16 of the second relay strip
25
TARGET ECO I FEEDING, rev.09
TARGET ECO I FEEDING
6.2 Drop Settings
The following procedure shows how to
adjust the particular settings of each drop.
Select
3. Drop Settings*
* Accessible if drops are controlled individually
(the actuator is disabled in section 5.3).
• Select Drop #:
Select the desired drop. All following pa-
rameters are related to the chosen drop:
Status:
Select “Yes” to enable the chosen drop;
select “No” to stop using it.
Animal age:
Set the age of the animals that are being
served by the drop. This age is automati-
cally increased every day at the Time of
reset.
Ration curve:
Select which ration curve the drop uses.
Accessible if ration curves are enabled (s. 5.3).
Drop Settings
Exit: Press BACK Change: Press Modify
Press to Select an item
Select Drop # 2
Status On
Animal age 1
Ration curve # 1
Use Ration # 1
Feed during cycle #1 ? Yes
Feed during cycle #2 ? No
Feed during cycle #3 ? No
Feed during cycle #4 ? Yes
Feed during cycle #5 ? No
Feed during cycle #6 ? No
Feed during cycle #7 ? Yes
Feed during cycle #8 ? No
Use Ration #:
- If a ration curve is used:
This is the ration that is presently used
by the drop; the ration selection is de-
termined by the curve and cannot be
modified.
- If the ration curve is not used:
Select the ration that must be deliv-
ered to the drop.
Feed during cycle #1-8 ?
Select during which cycles feed is deliv-
ered to the drop.
Accessible if ration curves are disabled (s. 5.3).