TARAL VST 818, Руководство пользователя, Страница: 48 / 60

Filter
2. Blow with clean water to wash away remaining dust or straw.
CAUTION
Be careful not to damage the radiator since damaged or
deformed radiator will reduce the cooling efficiency.
Drain
1. Remove drain plugs (3 locations) and let the oil flow out.
2. Wrap the drain plugs with sealing tape and tighten it.
3. Enter new gear oil specified through filler port.
CAUTION
Replace oil at the first 50 hours and in every 200 hours
thereafter.
CLEANING THE INSIDE OF RADIATOR
Clean radiator and engine coolant system with cleanser in the
following cases:
After 600 hours of operation
Adding anti -freeze.
Replacing coolant eliminating anti-freeze. (for export trac-
tors)
CAUTION
For cleaning the radiator, read the instruction on cleanser
carefully, and observe the instruction.
CLUTCH PEDAL ADJUSTMENT
CLEANING THE RADIATOR SCREEN
1. Open the bonnet and remove the radiator screen.
2. After removing large dust, straw, etc. with hand, rinse with
clean water.
CLEANING THE RADIATOR
1. Check the radiator for clogging, and remove large
dust, straw, etc. if any, first with hand.
Clutch pedal
Radiator
Clutch pedal free play is very important and it must be always
maintained to be correct. If there is no free play, the clutch disc
will wear quickly, while too much free play will cause difficult
disengagement of the clutch even if the pedal
is fully depressed, resulting in hard gear shift.
Amount of free play should be 0.79 to 1.18 in. (20 to 30 mm)
Adjust it in the following manner:
1. Remove the snap pin and clevis pin of clutch rod.
2. Adjust the amount of play by turning the joint.
Turn-in……......…..Reduces the amount of play
Turn-out……………Increases the amount of play
NOTE
This adjustment is important for maintaining the clearance
between the release lever and the release
bearing to obtain a smooth gear shift and transfer all
the driving power to the transmission.
38