Peripheral Equipment
237
6.1.4 Data
port
The data port(s) are implemented as Data Communications Equipment (DCE). The connector
used is female 9-pin D-subs.
NOTE! Data port 2 is used by both Wave II Camera and Precision HD Camera and has different
pin-out scheme for the different use.
The TANDBERG main camera is normally connected to data port 2 and pin number 4 provides
12V DC / 1 Amps to the main camera. Otherwise the pin-outs for both data ports are the same.
Signal name
Direction
Pin number
Carrier detect, CD
From DCE
1
Receive data, RXD
From DCE
2
Transmit data, TXD
To DCE
3
Data terminal ready, DTR
From DCE
4
Signal ground, GND
5
Data set ready, DSR
From DCE
6
Ready to send, RTS
To DCE
7
Clear to send, CTS
From DCE
8
Ring indicator, RI
From DCE
9
Data Port 2 with Precision HD Camera
Pin-outs for the THSI (TANDBERG High Speed Interface) on data port 2:
Signal name
Direction
Pin number
Video LVDS +
To DCE
1
Receive data, RXD
From DCE
2
Transmit data, TXD
To DCE
3
Power, +12V
4
Signal ground, GND
5
Video LVDS -
To DCE
6
NOTE! The enclosed TANDBERG Camera Cables must be used! Do not use other camera
cables as this might cause problems with the transfer of video signals from the Precision HD
Camera.
Содержание 8000 MXP
