General Use
157
5.3.9 VNC
Settings
VNC Settings is necessary when using a VNC presentation. Please see chapter,
PC Soft
Presenter and VNC,
for more information in how to use VNC.
Address
The IP-address of the PC with the VNC software installed. To find the IP-
address of the PC, place the mouse pointer on the VNC program icon in the
lower right corner of the Windows taskbar. You can also select Command
Prompt from the Startup-menu\Run and type cmd then enter. This will open a
command window and from here. Type “ipconfig” and press enter.
Display
Number
The display number for VNC is 0 and upwards. If you are using WinVNC,
double-click on the icon on the taskbar to view WinVNC properties. This
number should correspond with Display Number in this menu.
Password
Enter the same password as specified in WinVNC properties. The password
will be shown as asterisk signs (*) the next time you enter the menu.
Содержание 8000 MXP
