Tanco 1300 Series, Руководство оператора

Страница: 23 / 112

Tanco Autowrap - 1310 / 1320
Operator’s Manual
22
Operation
Operation in Automatic mode
The controller is generally used in automatic mode for ‘one touch wrapping’. Note the controller counts in steps of 2, because for each revolution of the wrapping arm two wraps of film
are applied.
1. ‘A’ on the centre of the display indicates that the controller is set in Automatic mode. If not, press (L6) to select.
2. With the rollers in the open position (step 5), bring the machine up to the bale.
3. Press (R5) to move the rollers to the closed position.
4. Press (R6)switch to commence the automatic wrapping cycle. The wrap arm will first unfold to the straight position. It will then complete the target number of wraps, on the last half
revolution the wrap arm will return to the folded position, come to a stop after passing the cutter and reverse to the centre.
5. Press (L5) switch to move the rollers to the open position to unload the bale.
Manually Interrupting an Automatic Wrapping Cycle
Press (R1) to bring the wrapper to a controlled stop. Pressing (R3) will continue the Auto-Wrap cycle from where it stopped.
For safety reasons; if it is necessary to work on the machine (e.g. in the event of a film break or the film running out), then it is strongly recommended that you then switch the con-
troller off via the red stop button and disengage the machine power source. Pressing (R3) after switching the controller back on will resume the auto-wrap cycle from where it stopped.
Unless it is an emergency situation, do not bring the machine to a stop by pressing the red stop button as this will impose unnecessary strain on the machine.
Manual options in Automatic mode
With the controller in automatic mode, the following manual functions are possible.
- Slow Wrap (L3): This button will rotate the wrap arm at slow speed (not during an automatic wrapping sequence).
- Fast Wrap (R3): This button will rotate the wrap arm at normal fast speed. This button will also resume an automatic wrapping cycle if interrupted.
- Reverse Wrap Arm (L4): This button will rotate the wrap arm in reverse at slow speed (not during an automatic wrapping sequence).
- Pause Bale Rotation (R5): Holding down this button during an automatic wrapping sequence will stop the bale rotating and so will add more film to a particular part of the bale. Release
the button when sufficient additional film has been applied.
- ADD 1 WRAP (L1): Each time you press this button an additional wrap will be put on the current bale if the wrapping sequence is in progress or onto the next bale if the automatic cycle
has not yet been started. You can add as many wraps as required.
7. EH CONTROLLER INFORMATION