Tanaka TCH24EA(50ST), Инструкция по эксплуатации

Страница: 6 / 56

English
6
Before using your machine
• Read the manual carefully.
• Check that the cutting equipment is correctly assembled and adjusted.
• Start the unit and check the carburetor adjustment. See “MAINTENANCE”.
NOTE: Equivalent noise level / vibration level are calculated as the time-weighted energy total for noise / vibration levels
under various working conditions with the following time distribution:
* 1/5 Idle, 4/5 racing.
WHAT IS WHAT? (Fig. 1)
Since this manual covers several models, there may be
some di ff erence between pictures and your unit. Use the
instructions that apply to your unit.
A: Starter handle
B: Fuel tank
C: Fuel tank cap
D: Throttle trigger
E: Throttle trigger lockout
F: Front handle
G: Rear handle
H: Spark plug
I: Hand guard
J: Cutting blade
K: Air cleaner cover
L: Ignition switch
M: Blade guide
N: Protection plate (if so equipped)
O: Gear case
P: Choke lever
Q: Lock button
R: Priming bulb
S: Blade case
T: Combi box spanner
U: Handling instructions
WARNINGS AND SAFETY
INSTRUCTIONS
Pay special attention to statements preceded by the
following words:
WARNING
Indicates a strong possibility of severe personal injury or
loss of life, if instructions are not followed.
CAUTION
Indicates a possibility of personal injury or equipment
damage, if instructions are not followed.
NOTE
Helpful information for correct function and use.
Keep for future reference.
WARNING
THIS HEDGE TRIMMER CAN CAUSE SERIOUS
INJURIES. Read the instructions carefully for the
correct handling, preparation, maintenance, starting and
stopping of the hedge trimmer. Become familiar with all
controls and the proper use of the hedge trimmer.
Operator safety
○ Wear head protection (1). ( Fig. 2)
○ Always wear a safety face shield or goggles (2). ( Fig. 2 )
○ Wear approved hearing protection (3). ( Fig. 2 )
Long-term exposure to noise can result in permanent
hearing impairment.
Pay attention to your surroundings. Be aware of any
bystanders who may be signaling a problem.
Remove safety equipment immediately upon shutting o ff
engine.
○ Always wear heavy, long-sleeved shirts (4) and long
pants (5) and non-slip boots (6) and gloves (7). ( Fig. 2 )
Do not wear loose clothing, jewelry, short pants, sandals
or go barefoot.
Secure hair so it is above shoulder length.
○ Do not operate this tool when you are tired, ill or under
the in fl uence of alcohol, drugs or medication.
○ Do not operate the tool at night or under bad weather
conditions when visibility is poor. And do not operate the
tool when it is raining or right after it has been raining.
Working on slippery ground could lead to an accident if
you lose your balance.
○ Never let a child or inexperienced person operate the
machine.
○ Beware of overhead power lines.
○ Do not start the engine if there are any fl ammables such
as dry leaves, waste paper or fuel in the vicinity.
○ Never start or run the engine inside a closed room or
building. Breathing exhaust fumes can kill.
○ Keep handles free of oil and fuel.
○ Keep hands away from cutting equipment.
○ Do not grab or hold the unit by the cutting equipment.
○ Gloves should be worn when installing or removing the
cutting blade. Failure to do so may result in injury.
○ When the unit is shut o ff , make sure the cutting blade has
stopped before the unit is set down.
○ When operation is prolonged, take a break periodically
so that you may avoid possible Hand-Arm Vibration
Syndrome (HAVS) which is caused by vibration.
○ If the cutting mechanism strikes any foreign object or
the hedge trimmer starts making any unusual noise or
vibration, shut o ff the power source and allow the hedge
trimmer to stop. Disconnect the spark plug wire from the
spark plug and take the following steps:
• Inspect for damage;
• Check for, and tighten, any loose parts;
• Have any damaged parts replaced or repaired with
parts having equivalent speci fi cations.
WARNING
○ Always operate the tool with proper protective equipment
and clothing. Failure to do so may result in accidents
such as burns or injuries. ( Fig. 2 )
○ Do not touch the spark plug area or high voltage during
operation. Doing so may result in electric shock.
○ Do not allow children near the tool during operation.
○ Do not touch the engine, mu ffl er cover or exhaust vent
during or shortly after operation. Doing so may result in
burn or injury.
○ Antivibration systems do not guarantee that you will
not sustain Hand-Arm Vibration Syndrome or carpal
tunnel syndrome. Therefore, continual and regular users
should monitor closely the condition of their hands and
fi ngers. If any of the above symptoms appear, seek
medical advice immediately.
○ If you are using any medical electric/electronic devices
such as a pacemaker, consult your physician as well as
the device manufacturer prior to operating any power
equipment.
Unit/machine safety
○ Inspect the entire unit/machine before each use.
Replace damaged parts. Check for fuel leaks and make
sure all fasteners are in place and securely tightened.
00Book̲TCH24EA.indb 6 00Book̲TCH24EA.indb 6 2018/11/01 13:59:20 2018/11/01 13:59:20