tams elektronik
FD-R Extended
English
Problems in analogue mode
The decoder does not work in analogue mode.
Possible cause: The analogue mode is switched off.
Alter the
value for CV#29.
The decoder does not switch to analogue mode (or switches over
although it is still digitally controlled).
Possible cause: The value in CV#11 is set too high or too low.
Alter the value and check the settings in operation.
Problems with switching via switching inputs
After passing a permanent magnet in the rails no function is
activated.
Possible cause: The reed contact or the Hall sensor has been
mounted incorrectly.
Check the connections.
Possible cause: The distance to the magnet is too large or the
magnet is too weak.
Alter the position of the magnet (if possible)
or use a stronger one.
Possible cause: The magnet has been mounted incorrectly polarized.
Alter the mounting direction.
Possible cause: The function has been assigned incorrectly to the
switching input.
Check the settings in CV## 59-64 and 119-121.
Possible cause: The input IN3 is determined for the connection of a
servo (= default value).
Check the settings in CV## 167 and
168.
Page 51
