tams elektronik
FD-R Extended
English
Changing into the update mode
Execute the programm POM-update.exe, follow the helpfile. Proceed as
follows:
1. Make the settings for the update.
2. Enter the addresses of the function decoders FD-R Extended you
want to update.
3. Change into the update mode.
The lighting connected to the outputs AUX2 (F0r) of the decoders which
are chosen for an update start to flash slowly. If flashing quickly, the
decoder cannot be updated
because the decoder type does not correspond to the hex-file or
because the decoder´s firmware already conforms to the version of
the hex-file.
The concerned vehicles can stay on the track, they do not affect
updating the other decoders. As an alternative you can cut them from
current shortly in order to stop them flashing quickly.
Performing the POM-Update
After having changed into the update mode you can start the update.
The lighting connected to the outputs AUX2 of the decoders in update
mode stop to flash and show permanent lighting.
The duration of the update depends on the central unit in use and the
extent of the transferred data. The progress is shown in the screen
mask. As soon as the update has been finished the lighting start to
flash slowly. Cut the vehicles from current shortly. Now the vehicles are
in standard operation again.
When a fault occurs during updating, the update is interrupted and the
lighting starts to flash quickly. In this case restart the update after
altering the settings if necessary (see helpfile of the programm for
further information).
Page 49
