tams elektronik
FD-R Extended
English
Required materials
For mounting and connecting the decoder you need:
an electronic soldering iron (max. 30 Watt) or a regulated soldering
iron with a fine tip and a soldering iron stand,
a tip-cleaning sponge,
a heat-resistant mat,
a small side cutter, a wire stripper and a pair of tweezers,
electronic tin solder (0.5 mm diameter).
In order to connect decoders without soldered connecting wires you will
need wire. Recommended cross sections > 0.04 mm² for all
connections.
If you have a decoder without a soldered SUSI interface connector, you
might need a SUSI plug connector (e.g. item no. 70-01100).
For playing back the sounds you need:
a loudspeaker with an impedance of min. 4 Ohm and a rated load-
carrying capacity of min. 0,1 Watt.
If you want to release switching operations automatically, e.g.:
reed contacts 1 x closing contact (e.g. item-no. 84-53110)
and / or Hall-sensors (e.g. item-no. 84-53210) and
permanent magnets (e.g. neodymium magnets Ø 3mm, thickness
= 2mm, item-no. 84-53990).
If you want to use the output for the servo:
one servo,
a voltage supply for the servo (e.g. servo PCB item-no. 70-05900).
Page 5
