TallyGenicom T6212, Руководство оператора, Страница: 74 / 92

Operator Manual
3–38
IPDS Category (IPDS Only)
Address (Twinax Only)
This parameter sets the Twinax IPDS device address for the printer. This
feature allows the IPDS emulation to reside at a different address than the
standard Twinax SCS emulation, hence providing two virtual Twinax printers.
The default is Undefined.
Density
This parameter defines the dot density of the IPDS output. Low is 60x72, and
High is 144x144. Medium (120x144) is the default.
Dark Bar
This parameter has three possible settings: Low, Medium, and High, with the
default being Low. This affects the print density (and print speed) of bar codes
selected through any emulation of graphics language as follows: Low (60x72),
Medium (120 half spaced x 144), and High (120 full spaced x 144). This
feature also works in conjunction with the selection of bar code density used
by Code V and PGL (Normal vs. Dark). The densities will be set based on the
previous Dark Bar selection table.
Smooth Size
This parameter defines the character size at which the block character smooth-
ing algorithm is invoked. The default is 3, which means size 3 block characters
will be smoothed, but size 2 block characters will not.
Zero
Provides for the printing of open or slashed zero block character. Default is
slashed.
Host Override
The Host Override parameter gives you the option of allowing the host to
control DPI for Graphics and Bar Codes or to control Graphics and Bar Code
Density through the Control Panel. When Host Override is On, the host
controls Graphic and Bar Code DPI with the Execute Order Anystate (XOA)
command and Print Quality Control (PQC) Subcommand. When Host Over-
ride is Off, Graphics and Bar Code DPI is controlled through the Control Panel
settings for Density and DarkBar parameters. The default selection is On.