TallyGenicom T6212, Руководство оператора, Страница: 63 / 92

3–27
Chapter 3: Printer Menus and Configuring Your Printer
Ignore Term
Determines whether or not a line feed following the CR terminator, an SFOFF, or
an IGOFF command will cause a line feed to occur. There are two options: En-
abled (usually the default), and Disabled (the default for Genicom ANSI).
Disable: A LF following the CR terminator SFOFF or IGOFF command will
execute.
Example: ~SFOFF<cr><lf>
~IGOFF<cr><lf>
Enable: A LF following the CR terminator in the above example will not ex-
ecute.
Configurations Category
Your printer can save up to ten personalized configurations, so you don't have
to recreate configurations you use frequently. In addition, each configuration
you save can be tagged with a label of up to 15 characters. When you first
receive your printer, each label is a generic "CONFIG" followed by a number 1
through 10 (See How to Save Configurations, next).
Save
If you have a configuration you are going to use multiple times, you may want
to save it. You'll use this parameter to do this.
How to Save Configurations
1. Set up the printer parameters the way you want them.
2. Make sure the printer is Offline (press the Online/Offline key), and
press the Menu/Back key to enter Menu mode.
3. Use the Up or Down Arrow key to find the Configurations menu, and
press Enter.
4. Scroll through the list of configurations. If you have not labeled them
(see Config n Label) they will be listed as CONFIG 1 - CONFIG 10.
Press Enter to save your configuration into any of these slots.
Next time you want to use this configuration, use LOAD.