TallyGenicom T6212, Руководство оператора, Страница: 46 / 92

Operator Manual
3–10
IPDS
In the IPDS emulation, the margin settings are absolute in regards to column
number, so that changing the CPI also changes the physical location of the
margin.
Right Margin
You can place the right margin at any column number across the page. As with
Left Margin, the range of this value depends on the CPI. (Column 136 is the
Default selection). The right margin must be greater than or equal to the left
margin.
IPDS
In the IPDS emulation, the margin settings are absolute in regards to column
number, so that changing the CPI also changes the physical location of the
margin.
If a requested margin setting indicates a column number that is greater
than the maximum allowable for the current CPI, the printer will default to
the last valid setting.
The current value of the right and left margins reflects a physical location
on the form, and therefore, changes when the CPI setting changes. If the
physical location of the right or left margin does not exactly correspond
with a line position after changing the CPI (characters per inch) setting,
there will be no current setting indicator (asterisk).
Horz Adjust
The print position on the form may be adjusted horizontally in increments of
1/30th an inch. The default option is 0.
Vert Adjust
The print position on the form may be adjusted vertically in increments of 1/72nd
an inch. The default option is 0.
Print to End Of Form (EOF)
Before changing paper it is best to print to the end of the current form. This
parameter allows you to set up the printer to print to the end of the form auto-
matically. The settings are On and Off, with the default at Off.
For Print to EOF to function properly the last print line of the form must
come before the perforation. If the Form Length setting allows printing to
go over a perforation, it is possible for the printer to continue printing in a
paper out situation without any paper in the printer, which may damage
the printer.
If Print to EOF is ON:
The printer automatically prints to the end of the form then stops. The display
reads Paper Out, the alarm sounds, and the FAULT indicator illuminates. At
this point you can load the machine with more paper. After you load paper,
ensure that the platen gap is closed, adjust the top-of-form location and make
CAREFUL!