TallyGenicom T6200 Series, Руководство оператора

Страница: 84 / 92

Operator Manual
A–6
Table A–2. Paper/Printing Corrective Action
Problem Cause Corrective Action
The paper holes are wider than
normal after passing through the
tractors. Horizontal paper tension is too tight. Unlock and readjust the tractors.
Printed characters on heavy-
weight or multi-part paper are
smeared.
The Platen Gap is not set correctly. Open the Platen Gap.
The printed characters are too
light. The Platen Gap is out of adjustment
or the ribbon is worn out. Readjust the Platen Gap. If this
does not correct the problem,
replace the ribbon cartridge with a
new one.
The printed characters are
shakey
The Platen Gap is not set correctly. Adjust the Platen Gap.
(2) The tractors are too far apart. Unlock and realign the tractors.
The printed characters in one
line are shorter than normal. Vertical paper tension is too loose. Move the Paper Tension Lever
until the paper is taut but not too
tight.
The paper holes are elongated
after passing through the
tractors.
Vertical paper tension is too tight. Move the Paper Tension Lever until
the paper is taut
The paper comes out of the
tractors or the paper tears at the
right or left holes along the
edges.
(1) The vertical or horizontal paper
tension is incorrect. To change the vertical tension,
raise the Paper Tension Lever to
increase tension, and lower it to
decrease tension.
To change the horizontal tension,
unlock the upper right and/or lower
right tractor and move it left or right
to make the necessary adjust-
ment.
(3) Upper tractors not aligned with
the lower tractors.
Unlock and realign the tractors so
that the lower set is directly under
the upper set.
(4) The Platen Gap is not set
correctly. Open the Platen Gap.