TALEX Sp. z o.o.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. +48 59 821 13 40
e-mail.
User manual
OptiCUT disc mower
Page
32
of
59
Mower has greasing points at all main connections. Use only manual or foot lubricator filled
with grease. Clean the residues and the old grease before and after greasing, and
the utilize the contaminated absorbents.
The articulated telescopic shaft should be greased after removing it from the machine. The
telescopic part of the shaft should be greased not less frequently than every 8 hours of
operating the machine – with completely separated shaft and after removing any residues.
Every time before starting work, not less frequently than once a year, the level of
oil in the cutting bar and the bevel gear should be checked and filled if necessary.
The level of oil in the cutting bar should be checked after placing the mower on an even surface
by opening the oil filler plug (A), Fig. 18. The oil level should be within the range of 5
÷ 7
mm.
Gearbox oil level should be checked with the oil dipstick placed in the oil control-filler-drain
plug (A) , after opening it Fig. 18. The (B) position is the cutter bar vent.
Fig. 18. Gearbox oil inspection: A – filler, drain, dipstick
B – cutter bar vent
The oil in the gear should be replaced immediately after work, when the oil is still hot. In order to do
that, the following must be done:
-
Lift the cutting bar to the vertical position
-
Open the oil filler, drain and control plug (A) Fig. 18.
-
Drain the oil to the prepared container
-
Lower the bar to the horizontal position
-
Fill in new oil SAE90EP (in accordance with the quantity listed in the Table no. 1)
-
Check the level and close the plug (A)
