TALEX Sp. z o.o.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. +48 59 821 13 40
e-mail.
User manual
OptiCUT disc mower
Page
13
of
59
3. Intended use
The disc mower was designed to mow all low stem green plants growing on meadows and
fields,
on flat, stoneless surfaces.
The lightweight disc mowers are not resistant to stones. If the machine is
operated on stony surface of the cultivation, it may cause frequent
replacement
of blades and discs.
In rare instances, the cutting bar is also damaged, which is
not covered by the warranty.
This machine accelerates the agricultural works due to high efficiency cutting and the proper
layout of the windrows. This type of windrow layout accelerates the drying process and
eliminates additional proceedings - spreading the windrows after cutting.
This type of mower is suspended on the three-point suspension system of the class II or III
tractor of the minimum power of 30KM. The mower is driven by the telescopic articulated
shaft and the hydraulic system with the actuator, which adjusts the position of the mower
during operation.
1 – Head stock
6 – Guard frame
2 – Hydraulic whose
7 – Cutting bar
3 – Head stock column with beam
8 – Support
4 – Hydraulic ram
9 – V – belts cover
5 – Guard bar
Fig.1 General design of the mower
The rotating discs equipped with blades are the basic operating components. This system is
driven by power input from the telescopic articulated shaft, bevel belt gear to the cutting bar.
The cutting bar consists of gear set transferring the power to the discs.
The fulfillment of the requirements for the use of the machine, the maintenance and repair by
the manufacturer and strict compliance with the manufacturer’s suggestions is a prerequisite
