□
Does the temperature
control of water stop
handle work properly?
□
Turn the water stop handle, check
that the water temperature is
adjusted properly and that there is
no abnormal noise.
* An abnormal gushing sound may be
emitted as water flows. (see page 16)
□
If the water temperature cannot be adjusted
properly or if there is an abnormal noise, there may
be a problem with the water mixing valve within
the basin. Stop using the product immediately.
□
Can the basin be filled
with water?
□
Check that the drain cap can be
used to block the drain and that
water filling the basin does not
drain.
□
When the water decreases quickly, there is a
possibility that the drain cap gasket has
deteriorated. The drain cap is a consumable part.
Immediately replace it. (See pa
ge 24.)
□
Does the basin,
backrest or seat
rattle?
□
Slowly push the rear end of the
basin, top of the backrest or the
front end of the seat in each
direction, and check whether they
rattle.
□
Rattling may cause incorrect operation or damage
in the main body, or cause it to fall over. Stop using
the product.
□
Has the mohair tape
degraded?
□
Check that the mohair tape has not
peeled off, and that there is no
significant dirt or degradation.
□
Clean the tape following the procedures outlined
in "mohair tape instruction manual" supplied with
the mohair tape (accessory).
□
Is water output from
the shower head
properly?
□
Feed the hot water, and visually
check that water is discharged
normally from the shower head,
water is not leaking from the air
bubble fixture, or the hot water is
not turbid.
□
If hot water is not fed normally, clean the inside of
the shower head. (See page 22.)
□
If water is leaking from the air bubble fixture or
from the base of the shower head, the internal
gasket may be worn out. If replacement is
required, contact your closest dealer.
□
Is the plating of the
water stop handle
peeled off?
□
Visually check the water stop handle
for flaws, cracks, or peeling of the
plated surface.
□
Flaws, cracks, or peeling of the plated surface
may result in injury of hand. If they exist,
replacement of the handle is required.
Contact your closest dealer.
□
During operation or maintenance,
check that there are no burrs or
irregularities on the surface.
Inspection item
Inspection method
If the inspection results show defects
To ensure that this product can be used for a long period of time, conduct the inspections below.
Procedures for Daily Inspections
■
Inspect the product every day
31
□
Is the backrest
operating properly?
□
Press the reclining pedal, and
check that the backrest is reclining
properly.
□
For replacement of broken wires,
contact your closest dealer. Emergency operation
to recline the backrest manually is available.
(See page 16.)
【
If the wire is snapped
】
□
If some lines of the hot water from shower jump
out, there is a possibility that sprinkling filter unit
is got blocked by water scale or dirt .
Remove the sprinkling filter unit and clean it.
(See pages 22.)
