Takagi AT-KJr3U-IN, Инструкция по установке и руководство пользователя

Страница: 42 / 64

42
Page
TEMPERATURE SETTINGS
-Set temperature-
Normal Operation
Owner's Guide
Operation
Screen on the controller
Built-in controller Remote controller
1.
Turn on the 120 VAC power supply to the unit (the water
heater or the multi-unit controller).
2.
Press the "ON/OFF" button on the controller in order to
turn the controller on.
3.
When ON, the STAND BY LED is lit.
4.
It shows the set temperature on its display as shown in
the picture on the right. (EX.: 120 °F)
5.
Press the "HOT" button or the "COLD" button to set the
temperature setting of the unit.
Increasing temperature from 120 °F (50 °C) to 125 °F (52 °C) :
1. The water heater must be in Stand By to increase the
temperature.
2. Press the "HOT" button to set 120 °F (50 °C).
3. Press and hold the "INFO" button and the "HOT"
button for at least 3 seconds. The remote will emit a
beep and change to 125 °F (52 °C).
4. To increase the set temperature further, press the
"HOT" button. You can increase the temperature
setting up to 140 °F (60 °C).
Increasing temperature above 140 °F (60 °C)
-510C model only-:
1. The water heater must be in Stand By to increase the
temperature.
2. Press the "HOT" button to set 140 °F (60 °C).
3. Press and hold the "INFO" button and the "HOT"
button for at least 3 seconds. The remote will emit a
beep and change to 145 °F (63 °C).
4. To increase the set temperature further, press the
"HOT" button. You can increase the temperature
setting up to 160 °F (70 °C).
(EX.: 120 °F)
°F 100 105 110 115 120* 125 130 135 140
°C 38 40 43 45 50* 52 55 57 60
a) For 110U (AT-KJr3U-IN/OS) and 310U (AT-K5U-IN/OS)
°F 100 105 110 115 120* 125 130 135 140 145 150 155 160
°C
38 40 43 45 50* 52 55 57 60 63 65 68 70
b) For 510U (AT-D3U-IN/OS)
*Factory setting (Default): 120 °F
Following are the temperature set points that are available with your built-in controller or remote
controller:
-Temperature table of controller-