Takagi AT-KJr3U-IN, Инструкция по установке и руководство пользователя, Страница: 30 / 64

30
Page
TEMPERATURE REMOTE CONTROLLER
-Included Accessories-Outdoor models only-
It is also an optional accessory as a second remote for the indoor models. The optional remote con-
troller doesn't come with the remote cable. Refer to p. 9.
Mounting and wiring the remote controller
1.
Take off the “
Back plate
” from the remote controller with a flat head screwdriver.
(Fig. A and B)
2.
Attach the “
Back plate
” on the wall with the two provided screws.
(Fig. B)
Fig. B
Back plate
3-1/4 inches
Attach the screws
Cut out the partition with pliers
Main body
Fig. A
Main body
Twist
Press and twist flat head
screwdriver against the cutout.
Check that these items below are included with the remote controller.
Temperature
remote controller*
Screws Manual Remote controller cable
Qty: 1 Qty: 2 Qty: 1
Qty: 1
Installation
Installation Manual
*
9009069005 (TM-RE42)
This remote controller is NOT waterproof.
The water heater can only have one remote controller at a time.
Do not install in high temperature environments, high humidity conditions out-
doors, in direct sunlight, or within the reach of children.
Make sure the remote controller does not come into contact with water or oil.
• Do not place the remote control wiring close to other wires from other
products.
• Do not extend the remote control wiring more than 400 ft. (122 m.)
CAUTION
-Installation-