Takachiho Sangyo VerifierG2 MPL-H10S, Руководство по эксплуатации

Страница: 32 / 37

- 30 -
8-8. Probe for non-metallic pipe
A Probe, supplied as optional equipment, is a small waterproof transmitter emitting a signal that is traced by the
Receiver.
The Probe can only be used in the non-metallic pipe.
Note : The metal pipe conceals a signal so that the Receiver cannot detect the signal. Use Direct connection mode.
Battery check
a) Set the rotary select switch to BATT.
b) Check if the green lamp is ON.
c) If the lamp is OFF, replace all batteries with new ones.
Replacement of batteries
a) Unscrew the top cover and open the battery compartment.
b) Four 1.5V AA (LR-6, NEDA15A) batteries are placed in series.
c) The proper polarities for the batteries are shown on the battery holder.
Output setting
a) OUTPUT LOW: 0.7 ft to 5.8 ft ( 0.2 m to 1.8 m )
Þ
less than 4ft / 1 m
b)
OUTPUT HIGH:
5.9 ft to 16 ft ( 1.8 m to 5 m )
Þ
more than 4 ft / 1 m
Mini-Probe Small probe for 1" Fiber optic duct or non-directional boring tools
Lamp
Attach the Sewer probe to the rodding tool and
insert the probe into the pipe.
(+) (-)
Replacement of batteries
Attach the Mini-probe to the rodding tool
M10(mm) thread
*Mini-probe doesn't have battery check function.
Check the transmission of the probe on the ground
before locating.
PT3/8” (Pitch 3/8”)
Attach the Sewer probe to the Pulling eye with the
pulling wire and pull the probe with the wire.
Attach the Mini-probe to the
Pulling eye