Tajfun RCA 330 JOY, Инструкция по эксплуатации и техническому обслуживанию

Страница: 20 / 40

20
During feeding, the trapdoor rises and stays in a horizontal (support) position until the sawing
stage is completed or until you close the cover and press the green button (RESET). The trapdoor
remains in the support position even when the cover is opened. To lower it, close the cover and
press the green button twice.
During feeding, the cutting length limiter moves closer too.
6.3. SAWING
The chainsaw operates only during the sawing cycle, otherwise it is at standstill in the home
position. Start the sawing by pulling the main control handle backwards. The sawing process
includes 2 stages. In the first stage, you fix the log with the log holder, and in the second, the
movement of the saw bar - sawing begins. During the sawing process, the control handle must
be held in the “backward” position, otherwise the saw bar will return to its original position. When
the saw bar reaches the bottom position, the trapdoor opens and the cut log falls safely into the
splitting chamber. At the end, the saw bar returns to its original starting position
The force used by the cylinder to push the saw bar is factory set and
must not be modified.
The
saw bar operation speed is also set to a fixed value. The sawing speed varies depending on the
sharpness of the cutting chain and type or diameter of wood.
Prior to sawing always check the sharpness and tension of the chain and the level of the
chain lubrication oil!
The wood must remain in the fixed position during sawing. Take extra care when cutting the
last piece – both clamps must be well fixed.
The movement of the wood during sawing can
damage the saw bar and the cutting chain!
The trapdoor ensures a smoother falling of cut logs into the splitting chute and is in the horizontal
(supporting) position during sawing. It opens when the saw bar is in the bottom position, but
can be opened at any time by pressing the green button on the main control handle. This is
particularly useful when cutting warped wood, which leans on the trapdoor during sawing and
pushes the saw bar from the side thus subsequently interfering the sawing operation. Regularly
clean and, if necessary, replace the filter in the chainsaw drive. The dirty filter prevents the clutch
and belt cooling air from entering the machine thus decreasing the service life of these elements.