Mode:
The interface can execute passive or active RIP. When executing passive RIP, the interface
revises its routing table based on the routing update information it receive, but does not advertise
self-routing information to other routers. When configured for active RIP at specifies interface
acts as a full router; it not only listens for updates but also advertises it routing table information
every 30 seconds.
* Passive
Enable Passive RIP. (Receive RIP packet only)
Active
Enable Active RIP. (Receive and send RIP table)
Send_Version:
Controls the version(s) of RIP advertisements. Available with active RIP only.
OFF
Disable the version(s) of RIP advertisement.
* RIP-1
Enable the RIP version 1 advertisement.
RIP-2
Enable the RIP version 2 advertisement.
Reveive_Version:
Controls the version(s) of RIP updates that are accepted.
OFF
Disable the version(s) of RIP upgrades that are accepted.
RIP-1
Enable the version of RIP-1 upgrades that are accepted.
RIP-2
Enable the version of RIP-2 upgrades that are accepted.
* RIP-1&2
Enable the versions of RIP-1 and RIP-2 upgrades that are accepted.
Default Route:
Controls and sets the WANpro to advertise itself as the default router.
* 0
Disable
1~15
Enable and specifies the number of hops to a destination.
Horizon:
Controls the spilt horizon and poison reverse mechanisms. Available with active RIP only.
* SPLIT
Split horizon
POISON
Poison reverse
Next Hop Advertise:
Specifies whether or not the next hop value is included in the RIP version 2 advertisements.
Available with active RIP only.
YES
Next hop value will not be included in the RIP version 2 advertisements.
* NO
Next hop value will not be included in the RIP version 2 advertisements.
Sub Accept:
Controls whether or not subnet routes are accepted in updates.
* YES
Subnet routes will be accepted in updates.
NO
Subnet routes will not be accepted in updates.
Sub Advertise:
Controls whether or not the RIP advertises subnets. Available with active RIP only.
* YES
RIP advertises subnets.
NO
RIP does not advertise subnets.
NOTICE:
The " * " mark means the default value of RIP parameter.
41
