WANpro 2000i
WANpro 2000i
PC
PC
PC
PC
PC
PC
Site A
10.0.0.1/30
Site B
10.0.0.2/30
Ethernet
Ethernet
Pair Copper Wire
IDSL-NT Mode
IDSL-LT Mode
The above diagram shows the IDSL PPP link, configuration of your WANpro 2000i could be like
follow.
Site A (10.0.0.1/30)
Site B (10.0.0.2/30)
Data Rate
128 k
Data Rate
128 k
NTU mode
<NT>
Test Loop
Disable
NTU mode
<LT>
Test Loop
Disable
Local IP
address
10.0.0.1 Local
IP
address
10.0.0.2
NetMask 255.255.255.252
NetMask 255.255.255.252
Encapsulate
<PPP>
Remote IP
address
0.0.0.0
Encapsulate
<PPP>
Remote IP
address
0.0.0.0
You should configure the IDSL NTU (Network Terminal Unit) in to the proper mode, IDSL data
rate should be the same at both site.
Test Loop
function will be discuss at Chapter 9.
The standard PPP encapsulate can be setup as above table or you can assign the IP to the remote
site.
Site A (Local)
Site B (Remote)
Local IP
address
10.0.0.1 Local
IP
address
0.0.0.0
NetMask 255.255.255.252
NetMask 0.0.0.0
Encapsulate
<PPP>
Remote IP
address
10.0.0.2
Encapsulate
<PPP>
Remote IP
address
0.0.0.0
NOTICE:
The IP shown this section are examples. You should substitute the IP values shown with values
that are appropriate for your network.
32
