Taiden HCS-4800 Series, Инструкция по установке и эксплуатации

Страница: 131 / 233

5. Channel selection (for units with SI function)

When the CMU is connected to interpreter unit(s),
simultaneous interpretation function will work and
the channel selector will be activated. To use the
channel selector, an earphone must be plugged in.
When the earphone is plugged, the delegate can
select a suitable language to listen to by means of
the channel selector.
6. Volume control

The volume of the built-in loudspeaker can be
adjusted by LCD menu -> Speaker Volume on the
main unit;

When the earphone is plugged, its volume can be
adjusted by the earphone volume control of the
unit.
7. OLED display
After initialization, the following interface will be
displayed on the OLED:
For HCS-48U10CVS(N)E/50 and
HCS-48U10DVS(N)E/50 congress units, press the
“YES” or the “NO” key to active the operation menu, it
includes two sub menus: Call and About.

“YES” key: page up

“NO” key: page down

“ABSTAIN” key: enter
A. “Call”
The earphone shall be plugged to use the intercom
function. If not, it will remind you to plug the earphone.
If the current unit is using the intercom function, it will
remind you that the line is busy. Press the “ABSTAIN”
key to use the intercom function, and the following
interface at the left side is displayed. When the
operator approved your request, then the following
interface at the right side is shown:
B. About
Display the product information.
8. VIP unit

Any delegate unit can be assigned as a VIP unit by
the TAIDEN conference management system
software. At most 32 VIP units can be assigned;

As long as the active microphone capacity is not
full, the microphone of the VIP unit can be
activated freely;

If the active microphone capacity is full, the
microphone of the VIP unit cannot be turned on
unless one of the active microphones is
deactivated.
118