![background image](http://html1.mh-extra.com/html/tacx/t1670/t1670_user-manual_3185056043.webp)
43
Assembling Basic
Connecting the Basic Computer
After placing the bike in the trainer, you can connect the computer as follows:
1
Assemble the computer using the two rubber clamps
P
on the handlebars (fig. 4).
2
Connect the computer to the unit with the cable
Q
. Make sure that the cable is out of the way
so you won’t touch it with your shoes or pedals while cycling.
3
Place the small magnet in front of the cadence
R
on the inside of the left crankshaft (fig. 5).
4
Assemble the magnetic sensor in front of the cadence measure
S
on the bottom of the left-hand
rear chain-stay. Make sure the sensor is level with the magnet, with a distance of approximately
3 mm between the magnet and the sensor. Insert the sensor's cable in the unit. Make sure here
that the cable runs freely from the sensor and does not touch the wheel.
5Place the plug in the power point. Check reception of the cadence metre by pedalling
backwards. The word CAD will appear on the display. The Basic is now ready for use.
Perspiration and humidity could damage the printer plate in the computer. Do not use the Basic
in humid spaces and if necessary dry the display after use. This will prevent unnecessary damage.
Incorrect use and/or improper maintenance will invalidate the warranty.
S
S
R
R
Q
5
P
P
4
GB
Содержание t1670
Страница 2: ...2...
Страница 112: ...Notes 112...