Taarup BIO+ B4000, Руководство оператора

Страница: 66 / 78

66
Operator´s manual BIO bale processor B4000
6 Maintenance
Warning:
Never carry out adjustment or repair work, or
service and maintenance work, on the ma-
chine when in operation. Switch off the tractor
engine, remove the ignition key and wait for
the machine to come to a standstill before
working on moving machine parts. Shut the
hydraulic shut-off tap before entering the bale
chamber. Take care when opening and clos-
ing the chamber section. No persons may
remain in the moving area while chamber
sections are operated.
To ensure the efficient running of the bale
processor and to avoid premature repairs,
make sure that the machine is well looked-
after and that repairs are carried out in time.
6.1
Maintenance of mechanic components
6.1.1 Welding on machine
Disconnect the command panel and the elec-
tric cabinet before any welding is done on the
machine.
Ø Material 8.8 Material 8.8
M5 ............... 5.7 Nm ................. 50.5 lb.in
M6 ............... 9.9 Nm ................... 7.3 lb.ft
M8 ................ 24 Nm ................... 17.7 lb.ft
M10 .............. 48 Nm ................... 35.4 lb.ft
M12 .............. 85 Nm ................... 62.7 lb.ft
M16 ............. 210 Nm .................. 155 lb.ft
M20 ............. 400 Nm .................. 295 lb.ft
M24 ............ 1000Nm ................. 737 lb.ft
6.1.3 Chain tensioning
All drive chains are tightened elastically by
spring-loaded chain tensioners. The chain
tensioners are to be assembled in the chain
row so that they can move freely with no tor-
sion and that the wear on chains and chain
wheels is reduced to a minimum.
The given spring lengths of the chain tension-
er are to be checked regularly and re-adjust-
ed if necessary.
Chain tensioner spring lengths:
Cutting system drive, right-hand side ........................................................... 120 mm
Chain tensioner for roller drive bottom section ............................................. 120 mm
Chain tensioner for roller drive top section ................................................... 250 mm
Maintenance
6.1.2 Re-tensioning bolts
Check thoroughly all bolts of drawbar, top
section's hinge pins, wheels and wheel shafts
after 1 hour of use and thereafter weekly. All
other bolts and nuts should be checked after
8 hours of use and thereafter weekly.
Bolt tensioning torque