Taarup BIO+ B4000, Руководство оператора

Страница: 31 / 78

31
1
2
3 4
7
6
5
8
9
D
Z
L
L
4.5 Net binding
4.5.1 General
The numbers of net wraps should be selected
with the control panel. For bales that are
wrapped with stretch film, 1.5 wraps of net is
required as a minimum, while 2.5 net wraps
are required for bales with no further film
wrapping. If bales are to be shifted several
times, further net wraps are recommended in
any case.
Range of net wraps is 1.5 – 9.9, and the op-
tion for automatic or manual binding start-up
are carried out using the control panel, see
paragraph 5.
A second net roll can be located in front of
the bale processor together with the film rolls.
Warning:
When inserting new rolls of net and when
threading the net, switch off the tractor en-
gine and wait for the machine to come to a
standstill. Remove the ignition key. Do not
reach into the anvil and blade area - the
blade is under tension each time the top
chamber section is activated. There is a risk
of injury.
4.5.2 Installing the net roll, inserting the net
Open front panel of the top section. Posi-
tion new net roll on floor underneath the
net binding system, located with net end
underneath roll with end heading back-
wards
Move net brake unit to upper, locked posi-
tion. Remove empty net tube with net roll
shaft.
Slide net roll shaft into the new roll of net,
hook up chain and lift net roll onto it’s hold-
ers.
Unroll the net from the roll, place to the
rear of the brake tube (1), around the flex
guide (2), over the guide tube (3) and the
plastic net spreader (4). Release and low-
er the brake unit onto net roll.
Spread the start of the net folded in half
and insert between the rubber roller (5)
and the aluminium roller (6), turn the rub-
ber roller (6) by hand or with an Allen key
on the mount (left-hand side) until the net
is securely gripped.
Note:
After any work on the net wrap system close
cover (D) as follows: First introduce the cover
into the rear plug (Z) and then slide over the
straps (L).
Be sure the cover is properly seated. If not it
can get loose and cause damage to the
machine.
Operating the machine