SystemAir Combi Unit Genius, Инструкции по установке, эксплуатации и обслуживанию, Страница: 28 / 124

Sort rooms according to their relevance
RECOMMENDATION
Sort the room order according to the relevance, e.g.:
Room 1 = Living room,
Room 2 = Bedroom,
Room 3 = Child room,
…,
Room 6 = Corridor,
This order will be applied to all website pages. Thus, it is clearly arranged.
The network connection is established after a moment.
Enter addresses and room numbers
NOTE
Observe the correct order!
1. Enter the addresses.
2. Set the room number (factory setting: 0).
Therefore, the error message
Communication error room x can be avoided during Alarm status .
If the error message still appears, it must be confirmed (see „8.1.4 Confirm Faults / Procedure“ page 32).
"
Enter the number of rooms or zones in the
Settings
on the website (=room sensors).
"
Enter the associated address.
»
The program compares the entered data with the room sensors.
NOTE
The same settings can be carried out via display.
7.3.3.2 Settings and Adjustment of the Air Volume Flows
The regulation of the volume flows must be done by a specialist. It is based on the data of the nominal air volume of controlled residen -
tial ventilation. These were calculated by Systemair or an external planner.
The supply air inlets must be suitable for the distribution of large amounts of air during heating and cooling. This is assured by the greater
number of valves at appropriate duct dimensions (exact planning required).
NOTE
Switch off the heat pump manually before adjusting the valves. The regulation of the valve is only possible when the
heat pump and consequently the secondary air fan does not start.
» Log on to the website with your service password.
» Switch off the heat pump via Manual/Auto .
Manual/Auto
Heat pump
Status Off
Control output 0 %
See also the control description.
28
Commissioning
Genius - V 1.0