Syntec 610-E5, Руководство по эксплуатации, Страница: 110 / 129

机床产品
/Machine Tool Products
–
610-E5/610-H5 5-Axis Wood Operation Manual
How to Operate 21 Series Controller
–
•
•
1.
2.
3.
•
•
•
•
•
•
•
•
1.
2.
3.
4.
Once CNC runs machining program with M99, this number will be accumulated until reset
Condition to reset part count( clear to 0 )
Change machining files
Required part count is reached( clear to 0 while "Cycle Start" again )
Modify the required part count, and the required part count is smaller than part
count( clear to 0 while "Cycle Start" again )
Work Record Function
Condition:
None
Description:
Once CNC continues machining when it meets M99, work record function will automatically record it.
Recording timing:
Required part count is reached
If 0 < part count < required part count, at the time of changing machining files
At the moment of modifying the required part count which must be smaller than the part count.
3.4.5 Alarm Processing
To avoid wrong operation causes danger to human and damage to machine, the system and PLC are equipped with
much of protection. When conditions are reached, system issue warning or alarm to user. This section introduces
how to inspect and troubleshooting alarm.
3.4.6 Network Setting
On the interface screen, press down "F8 Maintain" => "F2 Network Setting" to access IP address setting.
IP Address Setting : select "Specify an IP Address" when the PC connects with controller directly. And select
"Obtain an IP Address via DHCP" if using network connection via Dynamic Host Configuration Protocol
IP Address : if you select "Specify an IP Address", enter the free IP address
Subnet Mask : Enter the IP address for subnet mask (the same with PC subnet mask).