6
On the Outbound Mail Filtering - Nonlocal Relay panel, specify how you want
to relay outbound mail after filtering is complete.
You can use default MX lookup, select a host from the list, or define a new
host.
You can also specify a port. If you check Enable MX lookup for this host, you
must specify a host name (not an IP address) for that server.
For outbound mail addressed to a non-local domain, there is typically no relay
host to specify. If you choose Use default MX lookup, the Scanner will use
Internet MX records to deliver the mail.
7
Click Next.
8
On the Setup Wizard Summary panel, review the settings shown.
9
If you are satisfied with the settings, click Finish to save them.
If not, click Back to revise your settings, or Cancel to end without saving any
changes.
When the configuration is complete, the Scanner will contact Symantec to
download the latest antispam filters and antivirus definitions, and the default
antivirus definition download schedule will be in place (if you have installed
an antivirus license). You can alter this schedule from the Control Center.
Refer to the Symantec Mail Security for SMTP Administration Guide for more
information.
Setting up a Scanner
The instructions in this section only apply if you are adding a Scanner on a machine
different from the one hosting your Control Center.
Add a Scanner
Use the Add Scanner Wizard to set up a Scanner.
Note:
None of the settings you specify using the wizard are final until you click
Finish at the end of the wizard. If you step through all the panels of the wizard
and do not click Finish, you will not make any changes to configuration settings.
Installing Symantec Mail Security for SMTP
Setting up
38
