Installation et branchements
Page 13/52
IV.
Installation and wiring
1)
Installation conditions
To guarantee user safety and ensure correct operation of your
SYCLOPE TERE’O
®
,
please
observe the following installation instructions:
➢
Install the controller in a dry location
➢
The controller must be protected against rain, frost and direct sunlight
➢
The room temperature must range between 0°C and 50°C, with no condensation.
➢
Choose an installation location free from vibration, on a suitable support and with no
deformation
If these instructions are not observed:
➢
The controller is at risk of being damaged
➢
The measurements can be disrupted
➢
The warranty is not applicable!
2)
Installation of the wall-mounted controllers
Before performing the installation and electrical connections, remember to turn off the power!
The rating of IP65 is only guaranteed when the closing cover and the glass of the electric box
are closed and when the cable glands match the diameters of your cables and are correctly
sealed
►
Drilling three holes (
5-mm) according to the following drilling plan:
►
Insert the 5-mm plugs using a hammer
►
Insert the upper screw (top screw) first without completely tightening it
►
Insert the lower screws and tighten them
►
Tighten the upper screw
►
Use a spirit level to check for correct and accurate fixing to the wall.
