SYCLOPE TERE'O Touch CU/PT, Инструкция по установке, вводу в эксплуатацию и эксплуатации, Страница: 35 / 52

General use Page 35/52
Installation, commissioning and operating instructions SYCLOPE TERE’O Touch ®
CU/PT
d) Temperature
Pressing the « Temperature » button opens the programming window.
➢
Temperature sensor :
By checking this box, the temperature measurement input is activated. The measured
value will be displayed on the main screen.
➢
Temperature sensor calibration :
Once the sensor is activated you can calibrate it by changing the displayed value (read
by the sensor) and the actual value you are measuring. To do this, use the + and - arrows to
increase or decrease the value.
- Press the calibrate button to save your changes.
- Press the Clear button to erase a saved calibration.
e) Communications
Pressing the « Communication » button opens the programming window.
MODBUS section (Local communication RS485 port)
➢
Change MODBUS speed:
Use the buttons on either side of the selection area to scroll through the different
speeds in one direction or the other (300, 1200, 2400, 4800, 9600, 19200, 38400, 57600,
115200).
Temperature
Temperature sensor present
Temperature calibration
----
Clear
Calibrate
Temperature
Temperature sensor present
présent
Temperature calibration
28.5
Clear
Calibrate
Communications
MODBUS
speed
MODEM
Type
Parity
Stop Bit(s)
Address
APN SIM card GSM module
19200
Sans
2
1
AUCUN
Mysyclope setting
IP setting
WIFI setting