1080P SDI PTZ Camera User Manual
14
1.2
DIP Switch Settings
When you first power up the dome camera, the CURRENT PTZ address
and baudrate settings are displayed in the On Screen Display on your
monitor.
Note:
This section is only required if you need to change the default settings for the SDI speed
dome.
The DIP switch is used for setting the address and baudrate for the speed dome, with value ON=1
and OFF=0, as shown in Figure 1-11.
The SW1 switches from the first to the eighth are used to set the address. The SW2 switches are
used to set the baudrate. Please refer to the section 1.2.1 and 1.2.2 for detailed settings.
Notes:
The default dome address is 0. The default baudrate is 2400.
The speed dome is self-adaptive to the Pelco-P, Pelco-D and other Protocols. You don’t have to
set the RS-485 control protocol by DIP switch.
ON
1
2
3
4
5
6
7
8
1
2
Figure 1-10
DIP Switch Settings
DIP Switch
