1080P SDI PTZ Camera User Manual
10
11.
Carefully feed the cables through the pendant adapter and down through the stand until they
poke out the end where the mounting holes are as shown in Figure 1-6.
12.
Connect the cables as shown in Section 1.1.2 Connecting the Cables to the SDI coaxial cable
supplied in the kit, making sure that all connectors are secure and not under strain. Once
connected, push the connectors inside the wall mount to keep them secure.
13.
Next bolt the mount to the wall or other mounting surface. Be careful not to crush the wires
between the mount and the wall, make sure you don’t leave the camera hanging from the cable
while doing this.
Figure 1-6
Install the Wall Mount
Notes:
The installation of the mount can be done at this point in the camera setup or at any stage as
long as you have access to the wires and connectors to finish the connection to your DVR. Take note
of the small inspection panel as shown in Figure 1-6 that can be removed to access the connectors if
required at a later time.
Keep in mind you will have to create a hole or allow some other method to run the wires through
the wall and back to your DVR.
