Chapter 5: Local control of the equipment
User’s Manual: DT-02 Series
24
3.1
Transmission frequency
To configure the transmission frequency, once in the setup menu:
1.
With Up and Down arrows select line no.1 in the menu
2.
Press right button to enter the parameter and to be able to change it.
The cursor will be placed over the first digit of the frequency value.
3.
To increase or decrease the digit value use Up and Down buttons
respectively.
4.
To change the other digits, press the Left and Right buttons until the
cursor is over the digit to be changed.
5.
When the desired frequency has been set, press the Right button until
the cursor reaches the last digit and then press the Right button again.
The equipment will be locked onto that frequency
6.
To exit the parameter without saving the changes press repeatedly the
Left arrow until it is over the first digit and then press it again.
If the frequency set is out of range, for example in the transmitter which
works on 2200 to 2600MHz band, the equipment is locked to 2200MHz if
the frequency set is lower than 2200MHz or to 2600 MHz if it is higher.
Once the frequency has been set if there is any RF problem and the
equipment is not locked onto that frequency the frequency value blinks on
the display.
3.2
Transmission Power (Adjustable, Low, High)
This equipment allows the user to configure the output power of the
equipment. There are three options:
Adjustable (dBm)
Low
High
To select one of these options following steps must be followed:
Once 1n Setup menu;
1.
Using up and down arrows select line nº2 (Tx power)
2.
Press right button to enter the submenu.
To change from one option to another (High, Low, Adjustable) within the Tx
power menu right arrow should be pressed.
When adjustable option is selected the parameter appears ready to be
edited, a blinking cursor appears on the second digit. To change the value
of this parameter up and down arrows must be used. The transmission
power updates as the value of tx power is changed.
