•
Power
•
Foot
NOTE:
You cannot pair anything if airplane mode is on. Turn
off
airplane mode before
pairing. See 3.2. Airplane mode.
To pair a POD or sensor:
1. Go to your watch settings and select
Connectivity
.
2. Select
Pair sensor
to get the list of sensor types.
3. Press the lower right button to scroll through the list and select the sensor type with the
middle button.
4. Follow the instructions in the watch to complete pairing (refer to sensor or POD manual if
needed), pressing the middle button to advance to the next step.
If the POD has required settings, such as crank length for a power POD, you are prompted to
enter a value during the pairing process.
Once the POD or sensor is paired, your watch searches for it as soon as you select a sport
mode that uses that sensor type.
You can see the full list of paired devices in your watch from the settings under
Connectivity
»
Paired devices
.
From this list, you can remove (unpair) the device if needed. Select the device you want to
remove, and tap
Forget
.
3.20.1. Calibrating foot POD
If you have paired a foot POD, your watch automatically calibrates the POD using GPS.
For the
first
calibration, you should select a sport mode where the foot POD is used and the
GPS accuracy is set to
Best
. Start the recording and run at a steady pace on a level surface, if
possible, for at least 15 minutes.
Run at your normal average pace for the initial calibration, and then stop the exercise
recording. The next time you use the foot POD, the calibration is ready.
Your watch automatically re-calibrates the foot POD as needed whenever GPS speed is
available.
3.20.2. Calibrating power POD
For power PODs (power meters), you need to initiate the calibration from the sport mode
options in your watch.
Suunto Spartan Trainer Wrist HR
23
