Sutter Instrument TRIO MP-235, Руководство по эксплуатации

Страница: 15 / 40

13
TRIO MP-235 THREE-AXIS MICROMANIPULATOR SYSTEM OPERATION MANUAL – REV. 2.23 (20190130) (FW V2.2 & 2.3)
2.4 Electrical Connections and Initial Operating Instructions
Initially, you may want to simply connect the TRIO MP-235/M micromanipulator and the
ROE/Controller together and try some gross movements in order to get a feel for the controls
and how to make simple movements. It is perfectly acceptable to set the manipulators in the
middle of a bench top, make all electrical connections and then observe each unit’s
movement by eye.
CAUTION: Unless the TRIO MP-235/M micromanipulator electromechanical baseplate
is firmly bolted down to a breadboard or solidly to a firm surface, the TRIO MP-235/M is
likely to tip over when fully extending all of its axes, especially if its loaded with a headstage
that extends beyond the TRIO MP-235/M’s current center of gravity.
Upon deciding to directly install the TRIO MP-235 system in your rig, it is useful to follow
the initial setup procedure to learn how to move the units to allow easy access to the
mounting screws.
1.
With the power switch on the back of the ROE in the OFF (0) position, connect the power
adapter’s 24VDC cable to the POWER receptacle.
Figure 2-3. Rear of TRIO MP-235 ROE/Controller cabinet
2. With the power OFF (rear panel switch in the “0” position), connect a well-
grounded/earthed wire to the GROUND banana plug receptacle.
3. With the power OFF, connect the male end of the DB-HD-26 cable to the
MANIPULATOR connector on the ROE, the other end of which is connected to the TRIO
MP-235/M micromanipulator electromechanical. (See cautionary note below.)
4. Verify that the ten switches on the rear of the ROE are set as desired.
5. Power up the system by moving the power switch on the rear of the ROE to the “1”
position.