Sutter Instrument TRIO MP-235, Руководство по эксплуатации

Страница: 13 / 40

11
TRIO MP-235 THREE-AXIS MICROMANIPULATOR SYSTEM OPERATION MANUAL – REV. 2.23 (20190130) (FW V2.2 & 2.3)
Pressing and holding the RELATIVE button for three seconds at any location causes the
display coordinates to all zeroes. When activating relative mode, the display turns blue. To
return to viewing the absolute coordinates, tap the RELATIVE button to toggle back.
Finally, tapping the PULSE button causes a 3
μ
m advance in the diagonal. This rapid burst of
forward motion can assist in sharp electrode cell penetration.
All the electronics, except for a small power supply, are housed within the TRIO MP-235 ROE
and no separate controller or computer is required.
External computer control of the TRIO MP-235 is possible via the USB connector mounted
on the controller/ROE’s rear panel. The controller’s internal software is programmed with a
defined set of commands allowing for a wide range of micromanipulator/stage movements as
programmed in software residing in an external computer connected via USB.
2. INSTALLATION
When installing the TRIO MP-235 system for the first time, it is recommended that the
components of the system be installed in the following order: TRIO MP-235/M
electromechanical micromanipulator first, followed by the TRIO MP-235/E ROE/Controller.
2.1 Mounting Instructions
The following sections describe how to mount the TRIO MP-235/M manipulator to a stand
using the mounting adapter plate, how to adjust the pipette angle and how to mount
different headstages.
2.1.1
Mounting the TRIO MP-235/M to the Stand or Platform
The TRIO MP-235/M attaches to the mounting adapter plate using four M3.5x6 hex head
locking screws.
Figure 2-1. Side view of TRIO MP-235/M showing mounting adapter plate and lock screws.
The TRIO MP-235/M is shipped with the adapter plate in place. It is attached using four
tapered pegs, along with four locking screws.
Locking Screws Locking Screws