Sutter Instrument Lambda DG-4Plus/USB, Руководство по эксплуатации

Страница: 41 / 98

LAMBDA DG-4 & 5 PLUS/USB OPERATION MANUAL – REV.
1.01B3
(
20190607
)
29
NOTES:
1. The RING BUFFER will not run autonomously (i.e., in the MOVE ON COMMAND
mode). It must be triggered by a SYNC or STROBE PULSE.
2. The RING BUFFER cannot be appended. When you “record” the sequence it is “all or
nothing”, over-writing any previously recorded FILTER NUMBERS.
3.7.8.2 Storing the FILTER NUMBER Sequence
The controller will accept a sequence of up to 64 FILTER NUMBERS (only 32 into the non-
volatile memory) and store them in a “RING BUFFER”. To gain access to the SETUP RING
BUFFER menu, press the MODE key followed by the 8 key. Alternatively, you can “page”
through the mode selection menus by pressing MODE. The following menus will be
displayed:
Press 1 three times to scroll through the NEXT TWO PAGES to see the desired option or
press the 0 key to abort the routine and return to the MAIN MENU.
Press 8 to view the SETUP RING BUFFER menu or the 0 key to return to the MAIN
MENU. The following display will appear if you press 8:
Press 2 to begin recording a new sequence of FILTER NUMBERS. The following prompt will
briefly appear:
0=EXIT, 1=NEXT PAGE, 2 = TURBO BLANKING
3 = DISPLAY THE FIRST 4 FILTER VALUES
0=EXIT, 1=NEXT PAGE. 4= MOVE ON SYNC.
PULSE, 5 FOR MOVE ON STROBE PULSE
0=EXIT, 1=NEXT PAGE. PRESS 6 FOR MOVE ON
SYNC, INHIBITED BY THE STROBE LINE
0=EXIT, 1=NEXT PAGE. 7 = EDIT A FILTER
DEFINITION, 8 = SETUP THE RING BUFFER
0=EXIT. 1 = RUN EXISTING BUFFER, 2 = TO
CREATE NEW FILTER SEQUENCE. 3 = DISPLAY
ENTER THE FILTER NUMBERS. TWO ENTERS IN
SUCCESSION WILL END THE STRING.