Sutter Instrument Lambda DG-4Plus/USB, Руководство по эксплуатации

Страница: 40 / 98

LAMBDA DG-4 & 5 PLUS/USB OPERATION MANUAL – REV.
1.01B3
(
20190607
)
28
Press 7 to view the EDIT A FILTER DEFINITION menu.
At this point, enter the number 99 instead of a valid FILTER NUMBER. The following
prompt will appear:
Enter the desired FILTER NUMBER (0-15) as described in the MOVE ON COMMAND
section; for one digit values, press the desired numeric key followed by ENTER or press the 0
key before the desired numeric key; for two digit values press the numeric keys only.
Pressing the MODE key will abort the EDIT routine, return you to the first MODE
SELECTION menu and retain the current FILTER NUMBER settings. If you have entered a
FILTER NUMBER value (e.g., 4), the following edit screen will appear:
Now press the F1 key to increase the Output Galvanometer Value or press the F2 key to
decrease the Output Galvanometer Value. These keys can be briefly depressed and released
to increment or decrement the value slowly or they can be held down continuously (for more
than 2 seconds) to rapidly increase or decrease the value. When you are finished press the
ENTER key to return to the MAIN MENU.
3.7.8 Setup Ring Buffer Mode
[MODE/8]
3.7.8.1 General Information
The Lambda DG-4 controller will accept a sequence of up to 32 FILTER NUMBER values
into its non-volatile memory as part of the “RING BUFFER”. This sequence of FILTER
NUMBERS can then be “played back” during an experiment. It is possible to program a total
of 64 FILTER NUMBER values into the RING BUFFER but the additional 32 values are
stored in a volatile memory and will be lost if the Lambda DG-4 is turned off or RESET.
The values in the RING BUFFER can be stored and viewed while in any operational mode
but it can only be RUN from one of the “triggered” operational modes since the filter
changes are dependent on a STROBE PULSE or SYNC PULSE.
WHICH FILTER DO YOU WISH TO EDIT OR
CREATE
WHICH FILTERS OUTPUT DO YOU WANT TO ADJ.
FILTER NO. 4 CURRENT VALUE = 3919