Sutter Instrument Lambda DG-4Plus/USB, Руководство по эксплуатации

Страница: 34 / 98

LAMBDA DG-4 & 5 PLUS/USB OPERATION MANUAL – REV.
1.01B3
(
20190607
)
22
Press 5 to view the MOVE ON STROBE PULSE menu.
Press 1 to activate MOVE ON STROBE and return to the MAIN MENU or press 0 to abort
the mode selection routine and retain the current mode setting. The status of the operational
mode will be indicated in the lower line of the MAIN MENU display.
3.7.6 Move on Sync, Inhibited by the Strobe Line Mode
[MODE/6]
This mode combines the functions of the MOVE ON SYNC PULSE and the MOVE ON
STROBE PULSE modes (see above) to allow the capture of more than one video frame before
advancing to the next filter in the previously programmed series of FILTER NUMBERS
(Ring Buffer). In this mode the Lambda DG-4 controller will ignore the SYNC input until it
detects a state change in the STROBE LINE, from HIGH to LOW. Then it will advance to
the next filter in synchrony with the next vertical sync pulse that occurs. The computer
interfaced with the Lambda DG-4 must be set up to monitor the video signal and hold the
STROBE line HIGH if the number of frames to be captured with each FILTER NUMBER is
to be constant. This option might also be used to solve some timing problems that can result
when using inherently fast software or computers. Selection of this mode is made by pressing
the MODE key followed by the 6 key to get to the MOVE ON SYNC, INHIBITED BY THE
STROBE LINE menu. Alternatively, you can “page” through the mode selection menus by
pressing MODE. The following menus will be displayed:
Press 1 twice to scroll through the NEXT PAGE to see the desired option or press the 0 key
to abort the routine and return to the MAIN MENU.
0=EXIT, 1=NEXT PAGE. 4= MOVE ON SYNC.
PULSE, 5 FOR MOVE ON STROBE PULSE
ADVANCE TO NEXT FILTER ON STROBE IS OFF
PRESS 1 TO TURN ON, 0 TO KEEP IT OFF
10 = FILTER NUMBER, TURBO-BLANKING- OFF
INPUT = MANUAL MOVE ON STROBE PULSE
0=EXIT, 1=NEXT PAGE, 2 = TURBO BLANKING
3 = DISPLAY THE FIRST 4 FILTER VALUES