Sutter Instrument Lambda DG-4Plus/USB, Руководство по эксплуатации

Страница: 33 / 98

LAMBDA DG-4 & 5 PLUS/USB OPERATION MANUAL – REV.
1.01B3
(
20190607
)
21
Press 1 for the NEXT PAGE to see the desired option or press the 0 key to abort the routine
and return to the MAIN MENU.
Press 4 to view the MOVE ON SYNC PULSE menu.
Press 1 to activate MOVE ON SYNC PULSE and return to the MAIN MENU or press 0 to
abort the mode selection routine and retain the current mode setting. The status of the
operational mode will be indicated in the lower line of the MAIN MENU display.
3.7.5 Move on Strobe Pulse Mode
[MODE/5]
When this mode is active the controller will advance to the next filter in a previously
programmed FILTER NUMBER sequence (Ring Buffer) when a logic signal applied to the
STROBE input goes from low to high. The FILTER NUMBER sequence can be programmed
at your convenience and then executed later with precise timing (see SETUP THE RING
BUFFER). The FILTER NUMBERS can also be sent individually via the serial or parallel
port before the trigger event. This operational mode is selected by pressing the MODE key
followed by the 5 key to get to the MOVE ON STROBE PULSE menu. Alternatively, you can
“page” through the mode selection menus by pressing MODE followed by the 1 key. The
following menu will be displayed:
Press 1 for the NEXT PAGE to see the desired option or press the 0 key to abort the routine
and return to the MAIN MENU.
0=EXIT, 1=NEXT PAGE, 2 = TURBO BLANKING
3 = DISPLAY THE FIRST 4 FILTER VALUES
0=EXIT, 1=NEXT PAGE. 4= MOVE ON SYNC.
PULSE, 5 FOR MOVE ON STROBE PULSE
ADVANCE TO NEXT FILTER ON SYNC IS OFF
PRESS 1 TO TURN ON, 0 TO KEEP IT OFF
10 = FILTER NUMBER, TURBO-BLANKING- OFF
INPUT = MANUAL MOVE ON SYNC PULSE
0=EXIT, 1=NEXT PAGE, 2 = TURBO BLANKING
3 = DISPLAY THE FIRST 4 FILTER VALUES