SUPREME OXYLINE, Руководство по установке

Страница: 12 / 15

ELECTRONIC CONTROL PANEL
SET CLOCK
+
-
REGEN NEXT
6:00
SET
ALARM BUZZER START
SET CLOCK
+
-
REGEN
NEXT
22:00
SET
ALARM BUZZER END
COMPLETION: Similarly, set the time when the alarm is to
switch off.
Pressing the button „NEXT” causes going to the next
parameter. You can go back to the previous step anytime,
by pressing the button „REGEN”.
START-UP: SETTING THE TIME (MINUTES): Set proper
figure of „minutes” by pressing the buttons „+” or „-”.
Pressing the button „NEXT” causes going to the next
parameter. You can go back to the previous step anytime,
by pressing the button „REGEN”.
1
2
Step 11: Setting the display operation - By pressing the
buttons „+” or „-” set the mode of the display operation.
OFF mode - if the user does not take any action, the display
switches off after several minutes.
ON mode - causes that the display is switched on all the
time.
You can go back to the previous step anytime, by pressing
the button „REGEN”. Pressing the button „NEXT” causes
the return to the main display.
SET CLOCK
+
-
REGEN NEXT
OFF
SET
LIGHT NORMALLY
RETURN TO THE
MAIN DISPLAY
During the operation, the controller may show one of the
five screens. By pressing the button „NEXT” you can switch
over between the alternative screens.
The first screen always indicates the current time.
The second screen indicates the amount of water
expressed in litres per minute, which has flown through
(has been filtered) by the system.
The third screen informs whether the holiday mode is
activated (the holiday mode may be activated or
deactivated from this level). The holiday mode is
responsible for starting up the regeneration in case when
the time regeneration is switched off. Then, although
sufficient amount of water does not flow through the
system, the system goes into the regeneration mode to
flush periodically the filter bed.
The fourth screen shows the volume of water remaining to
the time of next regeneration
The fifth screen shows the number of days remaining to
the time of next regeneration.
GENERAL INFORMATION
If the regeneration is initiated on a given day, the message
„REGENERATION TODAY” appears on the screen.
SET CLOCK
+
-
REGEN NEXT
REGENERATION TODAY
LPM 3250
16:23
WED
At the moment the system goes into the regeneration
mode, the screen displays the information on the current
stage of the regeneration, as well as the amount of time
remaining to its completion.
REGENERATION MODE
SET CLOCK
+
-
REGEN
NEXT
8
SET
BACKWASH-AIR 10%
SEK